Deteksi Keausan Alat pada Proses Pengeboran Sumber Alam

Authors

  • Siana Halim Fakultas Teknologi Industri, Program Studi Teknik Industri, Universitas Kristen Petra. Jl. Siwalankerto 121-131, Surabaya
  • Felecia . Fakultas Teknologi Industri, Program Studi Teknik Industri, Universitas Kristen Petra. Jl. Siwalankerto 121-131, Surabaya

:

https://doi.org/10.9744/jti.14.2.123-128

Keywords:

Change point detection, drilling, mean time between failures.

Abstract

In this paper we applied change point detection methods for failures detection in the drilling process. We calculated the change points on three drilling parameters, i.e., the weight on bit, top drive torque and rate of penetration. Using the concept of reliability, we measured the time between change points as the time between failures. The minimum of mean time between change points from those three parameters is suggested to be the time for monitoring the drilling process.

Downloads

Published

2012-12-21

How to Cite

[1]
S. Halim and F. ., “Deteksi Keausan Alat pada Proses Pengeboran Sumber Alam”, Jurnal Teknik Industri: Jurnal Keilmuan dan Aplikasi Teknik Industri, vol. 14, no. 2, pp. 123-128, Dec. 2012.

Most read articles by the same author(s)

1 2 > >>